mR2-D2 Electronics

The R2 Dome contains alot of lighting features.   At the FRONT of the dome, there is a lens that flashes blue to red.   To the other side of this lens are 2 vertical LOGIC BOXES.   These are filled with randomly pulsing lights.

At the REAR of the dome is another round lens.  This one flashes from green to yellow.  Across the perimeter from this lens is the REAR LOGIC BOX.  This long rectangular is illuminated with randomly flashing lights.

The electronics below are available to help you achieve these lighting effects.

Each logic display set includes:

The driver board with LEDs pre-wired with battery clip and on/off switch. Tested thoroughly before shipment.

And your choice of either the front logic display transparency and laser cut grids, OR the rear logic transparency with laser cut grid.

Again, each kit is suitable for either one of the other logic display. You will need to get TWO driver boards to fufill the logic boxes for both the front and rear. Just buy some 1mm fiberoptic filament (not included) and you're ready to start wiring your logic displays!!

Each logic display kit is $115 for single set.   Tested before shipment so you're ready to start pluggin in the fiberoptic.

___________________

Add the red/blue main lens effect and the green/yellow lens effect (pre-wired, tested, and ready to install with on/off switch attached) for an additioanl $85 with the purchase of a logic board display set. That's both rear and front lens effects for $85 pre-wired and ready to install.

__________________________________________

Click photo to see PHOTO GALLERY!

________________________________