Robotics Servo Controllers

This controller board has 8 standard servo outputs and 2 Open collector transistor outputs, 3 buffered inputs and a direct processor connection, these 6 non-servo digital inputs and outputs can be used in the scripted program control of your robotic device. Pogramming and setup is acomplished using a PC with a USB port. The cable end must be a mini USB B connector for programming.

SconScript V2.5 Firmware

512 KB Off-Processor memory

Eight Buffered servo outputs

3 Buffered digital inputs

2 Open collector outputs

1 Flexable I/O

5.5 - 12 Volt operation

10 Mips processor

Small 2.2 X 1.8 inch size

USB Interface

Seperate servo power

Screw Terminals for Power

Supplied with PScon

Schematic diagram included

Quality components

Assembled and tested

Power source not included